Employment Opportunity / RFQ (Request for Quote).Quick Navigation DeskCNC Controller Board Top If I abandon DeskCNC and the controller, is there a comparable alternative? Should I bother to keep the drivers? It is assembled and can plug into Step and Direction controlled, stepper and servo driver boxes, used with parallel port software such as TurboCNC, EMC, and Mach2. circle pocketed with a 1/32 end mill - I tested it 5 times with a cycle time of about 6min35secĭoes anyone out there have some benchmark parameters that work? The IMSRV site has pdf files that are too small to read and just become pixelated when zoomed in. This item includes a DeskCNC controller card, installed in a metal enclosure. The program will run 2 times, and then will servo fault on run 3.Ī 1 in.
No screw or gib loading - one less thing to suspect. deskCNC controller description deskCNC 2nd generation controller description and connections deskCNC controller connection Carken 4 axis driver one A4 PDF data sheet Save the hassle of ordering from the USA, and maybe the extra pain of paying import duty You can buy your Geckodrives from us. I've pulled the motors off the machine to test. I have managed to post a program to cut pockets for my name logo (for headstock inlay), all nine letters of it.
I am planning to use the machine for doing small pearl inlay work, printed circuit boards, small hardware, wooden bridges and saddles (3 D?) for my guitar making shop.
I bought a used Sherline Mill with servo motors and DeskCNC with a Generation 2 controller. The only way of achieving this kind of manual control under DeskCNC is to temporarily switch control from the computer to the pendant, do the manual position adjustment using the pendant controls, and then switch back however, in the process of making the manual adjustment, the computer does not know how far the axes had been moved when under. It's been an adventure in non reliability.
0 kommentar(er)
